Entrance door fitting LIMARA (R) - knob/handle-set with pull handle - PZ 92 DIN L - brass - matt nickel
Please select design:
Surface
Distance
side of hinges
garniture type
More information
Description
- Material: Solid brass
Surface: Brushed - matt nickel-plated
Outer side: Fixed pull handle
Inner side: Moving handle
Direction of hinges: DIN left
Pull handle 190 mm
Lever handle 135 mm
Lever handle plate 50 x 295 mm
Pull handle plate 50 x 275 mm
Euro cylinder escutcheon 50 x 110 mm
Includes: expanding spindle 8/10 and screws
General product information
-
Brass door fittings
Our entrance door fittings are made of solid brass, an alloy of copper and zinc. They are manufactured in our brass foundry using the traditional artisan sand casting process. These entrance door fittings are direct reproductions based on our original models and templates.
Specific product information
-
Distance / euro profile cylinder perforation
Entrance door fittings are supplied with euro profile cylinder perforations (abbreviation: PZ) for mortise locks as standard. The door plates have a perforation for the knob or lever handle and a perforation for the profile cylinder. In Germany, there are two standardised distances for this: PZ 92 mm or PZ 72 mm, measured from the centre of the handle hole to the centre of the round part of the cylinder hole. Locks with a euro profile distance of 72 mm are often installed in flat entrance doors. Different dimensions may occur with old locks - other standard dimensions apply in other countries.
The fittings can also be manufactured with a round cylinder hole (Swiss standard distance 78 mm).
The distance is not relevant for door sets with roses.
The distance is not relevant for door sets with roses. Surfaces
Our brass fittings are available in three different surface finishes:- Brass polished, unlacquered, slightly pre-patinated - gold-coloured - will darken, become slightly duller and more irregular
- Brass shiny nickel-plated - shiny silver-coloured - may become slightly darker
- Brass matt nickel-plated - matt silver-coloured - may become slightly darker
Mounting and security
The historical appearance of our entrance door fittings takes centre stage. They are therefore not tested security fittings. However, all fittings have threaded sleeves soldered to the outer plate or outer rosettes so that mounting is done through the door. The set cannot simply be unscrewed from the outside. The visible screw holes are intended for additional mounting using wood screws and also have a design function.
On request, some of the fittings can be manufactured with a 10 mm thick outer plate (for an additional charge).Knob/handle-set / handle set
This pull handle set is designed as a knob/handle-set. This refers to the combination of a fixed pull handle on the outside of the door and a moving handle on the inside. The lever handle is connected to the lock with a knob/lever spindle.Knob/lever spindle / spindle thickness
Pull handle sets are supplied as standard with a knob/lever spindle with plate for push-through installation - 8 mm spindle with sleeve for 10 mm lock nut, galvanised steel, slotted on both sides, length 70 mm.
If your door is only drilled on one side, please let us know! In this case, we supply with a 10/8 mm dowel pin (for 10 mm lock follower, reduced to 8 mm), galvanised steel, length 70 mm.Side of hinges - DIN left / DIN right
For pull handle sets, it is important to specify the side of hinges of your door so that the lever handle and pull handle point in the right direction. For doors that open inwards, the sides of hinges are named as follows:- on the in
