Bathtub faucet series TAMAS - with standpipes - with hand shower - chrome-plated
More information
Description
- Material: brass
Surface: high-gloss chrome-plated
Handle: Solid brass chrome-plated
Free-standing bath filler mixer
With two solid standpipes for connection to the water pipe lying in the floor
With fork, hand shower and shower hose
with 1/2 inch spigot for connecting the shower hose
with Neoperl jet regulator and integrated backflow aerator and integrated backflow preventer
Height of tap 235 mm
Width of tap 220 mm
Projection of tap 155 mm
Height of standpipes 800 mm
Standpipes Ø 26 mm
Height to lower spout 680 mm
Total height 930 mm
Total projection 190 mm
Shower hose 1500 mm
General product information
- The nostalgic-looking taps in the TAMAS series are manufactured to German product standards and have a high-quality interior. They are only available in a chrome-plated finish.
Specific product information
-
Surface
The surface of this fitting is permanently protected against corrosion and wear with an insensitive two-layer chrome plating of nickel and chrome. Subsequent polishing by hand creates a brilliant, high-gloss surface. Manufacture
Our fittings are made of solid brass, which is moulded into individual components in various machining processes. After moulding, each component is sanded by hand to obtain an even, slightly rough surface as a base for the subsequent final coating.Technical interior
The taps are equipped with precise valve control: durable ceramic discs with diamond-like hardness and a reduced sliding surface reliably control the water jet. All cartridges can be easily replaced without the aid of a special tool. The valves are tested with a service life of 500,000 operating cycles. The valves are tested with regard to the following requirements: Tightness, mechanical and hydraulic process, mechanical wear behaviour, quality of the chrome-plated surface, noise behaviour, dimensions.The fittings can be completely dismantled into their individual parts, and therefore every component can be replaced.
Handle design
The nostalgic cross handles of this mixer tap have a soft design. The inlaid porcelain lenses are labelled hot/cold in German. Should a mishap occur, these can be easily replaced.
Mounting and care
-
Cleaning and care
Water contains limescale and other mineral components that can settle on the tap once the water has evaporated. Residues from various items such as toothpaste, body care products and cosmetics, as well as fruit and vegetable acids and wine, can also attack the coating. Therefore, rinse the mixer taps with clear water after each use.In order to maintain the high-quality surface of the mixer taps in the long term, careful daily cleaning is recommended. Do not use any aggressive or abrasive cleaning agents. Chlorine and bleaching agents, acids, ammonia and soda attack the surfaces and should not be used. Abrasive cleaning equipment, scouring powder and disinfectants should also be avoided.
The best cleaning agents are soap and water and a soft cloth. Be careful in areas with very hard water! Here, the alkaline components of the soap can combine with the limescale contained in the water to form so-called lime soaps, which are deposited as unsightly rims in the washbasin and on the fittings and are difficult to clean. In this case, use mild cleaning agents that are suitable for use on taps, e.g. the care product DECAL (HORUS). It protects the fittings from mineral residues and can be used as required.
Please note that damage caused by improper treatment or care cannot be recognised as a complaint.
Mounting
The tap is supplied with all the accessories required for installation. Detailed installation instructions are included. All work on the water installation should be carried out and checked by a specialist or under their direction and supervision. We accept no liability for damage caused by improper installation.
